8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
190 Chapter 15 Tascam FW-1884
Assignment Overview
A modifier button (such as SHIFT) shown below a button description indicates that the
button has an alternate function/use, while holding down this modifier.
Note: The FE-8 units only offer the Channel Strip section, so other facilities mentioned
in this document don’t apply. The FW-1884 ENCODERS section is, however, applicable
to the FE-8 channel strips.
The FW-1082 has no channel encoders, and offers an extended channel strip section.
ENCODERS Section (FW-1884 Only)
Control Assignment
FLIP Switches Flip mode between Off and Swap. In Swap mode, the parameter
controlled by the fader and encoder of each channel strip is swapped.
PAN Assigns Pan to encoders.
AUX 1 Assigns Send 1 level to encoders.
AUX 2 Assigns Send 2 level to encoders.
AUX 3 Assigns Send 3 level to encoders.
AUX 4 Assigns Send 4 level to encoders.
AUX 5 Assigns Send 5 level to encoders.
AUX 6 Assigns Send 6 level to encoders.
AUX 7 Assigns Send 7 level to encoders.
AUX 8 Assigns Send 8 level to encoders.