8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
182 Chapter 13 Radikal Technologies SAC-2K
Channel Strips Section
Troubleshooting
This section may help you to resolve a few common problems.
 The track/channel names are shorter than necessary, and the assignments don’t work
correctly: The SAC-2K is in an emulation mode (Logic Control or HUI, for example). To
resolve this issue, simply switch the SAC-2K power off, and then back on.
 The faders don’t work, and the locator display shows 00000000: You have manually
switched the SAC-2K to SLAVE mode. This, unfortunately, does not initialize some
settings required for proper communication. To resolve this issue, simply switch the
SAC-2K power off, and then back on.
Control Assignment
EQs Enters Channel view EQ Edit mode. Pressing the button repeatedly cycles
through all available EQ parameter pages.
Inserts/Sends Enters Channel view Plug-in Edit mode—edits the effect plug-in inserted
into the currently chosen Insert slot (of the selected channel). Pressing the
button repeatedly cycles through all available effect plug-in parameter pages
.
Dynamics —
MIDI —
Instrument Enters Channel view Instrument Edit mode—edits the instrument plug-in
inserted into the selected (Instrument) channel. Pressing the button
repeatedly cycles through all available instrument plug-in parameter pages.