8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
178 Chapter 13 Radikal Technologies SAC-2K
Assignment Overview
A modifier button (such as SHIFT) below a button description indicates that the button
has an alternate function/use, while holding down this modifier.
LCDs and Encoders
Channel Strips
Control Assignment
Left and middle LCDs Upper row displays the channel number when in a Mixer (multi channel)
view mode. The parameter name is shown when in a (single) Channel view
mode.
Lower row shows the parameter value of the corresponding encoder (the
one directly below the display).
Level meters are shown to the right.
Right LCD Upper row displays the name of the parameter being edited with the
corresponding encoder (the one below).
Lower row displays the parameter value (assigned to the encoder below the
display).
The Master Output level meter is displayed at the far right.
Encoders Edit the corresponding parameter—shown in the LCD.
Encoder push buttons Parameters with two values (On/Off): Switches between the two values.
Parameters that access items (plug-in selection, for example): Confirms pre-
selection.
At other times: Sets the parameter to its default value.
Control Assignment
Mute/Solo Switches Mute/Solo 1 to 8 buttons between Mute and Solo modes.
LED off: Mute/Solo buttons switch Mute state on/off.
LED on: Mute/Solo buttons switch Solo state on/off.
LED flashes: Mute/Solo buttons switch Record Enable state on/off.
SHIFT Sets Mute/Solo buttons to Record Enable mode.
Mute/Solo 1 to 8 Mute/Solo LED off: Enables/Disables Mute; LED displays Mute status.
Mute/Solo LED on: Enables/Disables Solo; LED displays Solo status.
Mute/Solo LED flashing: Enables/Disables Record Enable; LED displays
Record Enable (armed/disarmed) status.
SELECT 1 to 8 buttons Selects channel.
Exception: In Group mode, these buttons define group membership of the
channel.
Master Select button Switches Flip mode between Off and Duplicate.
Faders 1 to 8 Controls volume, or duplicates the parameter assigned to the encoder
above—if Flip mode is enabled.
Master Fader Controls the Master Level fader (if it exists—if not, controls Output 1-2 level).
EQ button Inserts a Channel EQ in the channel if no Channel is present.