8

166 Chapter 12 Mackie HUI
Assignment Overview
A modifier button (such as Shift) below a button description indicates that the button
has an alternate use, while holding down this modifier.
ASSIGN Section
Control Assignment
SEND A Assigns Send 1 level to V-Pots, and Send 1 to 4 levels to DSP V-Pots. While held
down, the scribble strips show the current Send 1 destination (a bus number).
SHIFT/ADD As above, for Send 6
SEND B As above, for Send 2
SHIFT/ADD As above, for Send 7
SEND C As above, for Send 3
SHIFT/ADD As above, for Send 8
SEND D As above, for Send 4
SEND E As above, for Send 5
PAN Assigns Pan to V-Pots.
Note: You must confirm any changes made with the DSP V-Pots by pressing the
corresponding V-Select button.
INPUT Assigns channel strip input to V-Pots. While held down, the scribble strips show the
current channel strip input assignment.
The four DSP V-Pots control the following parameters of the selected channel strip:
format, input, output, and automation mode.
Note: You must confirm any changes made with the V-Pots or DSP V-Pots by
pressing the corresponding V-Select button.
OUTPUT Assigns channel strip output to V-Pots. While held down, the scribble strips show
the current channel strip output assignment.
The four DSP V-Pots control the following parameters of the selected channel strip:
format, input, output, and automation mode.
Note: You must confirm any changes made with the V-Pots or DSP V-Pots by
pressing the corresponding V-Select button.
REC/RDY ALL Disables Record Enable button of all channel strips.
BYPASS Switches the INSERT buttons between Insert Select and Insert Bypass modes. See
Insert entry in Channel Strips table on page 169.
MUTE Switches the V-Select buttons between Send Position and Send Mute modes.
SHIFT Enables or disables Flip mode.
SELECT-ASSIGN Displays the V-Pot assignment as follows:
Pan, Snd1 to Snd8, S1As to S8As, In, Out.
SUSPEND —