8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
11
151
11 Mackie C4
Setting Up Your Mackie C4
A connected and powered Mackie C4 unit will automatically be detected when you
open Logic Express. You can use the C4 in an independent control surface group (with
other control surface icons placed above/below the C4 icon), or combined in a group
with one or more control surfaces (such as the Mackie Control—place the icon to the
right or left of the existing icons).
Although the C4 can be used independently, it is most useful when combined with
other control surfaces, particularly the Mackie Control. In this scenario, the C4 adds
eight channels in Mixer view. Using the C4 in its own control surface group allows you
to edit instruments and effects independently, while performing mixing and other
tasks on the Mackie Control or other control surface.
V-Pots, V-Selects
Functionality depends on the current view mode, and chosen overlay (see below). Each
V-Pot features a V-Select switch, built into the knob top.
 The top row (row 1) consists of V-Pots 1 to 8.
 Row 2 consists of V-Pots 9 to 16.
 Row 3 consists of V-Pots 17 to 24.
 The bottom row (row 4) consists of V-Pots 25 to 32.
V-Pot/V-Selects 1 to 8
When no overlay is active, V-Pots 1 to 8 (the top row) normally perform in the same
way as their counterparts on a Mackie Control or Mackie Control XT. See “Assignment
Zone” on page 68.