8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 9 Korg microKONTROL and KONTROL49 143
Solo/Mute Mode
This mode is enabled by pressing SCENE and Pad 2.
Rec/Select Mode
This mode is enabled by pressing SCENE and Pad 3.
User 4–8 Modes
These modes are enabled by pressing SCENE and Pad 4 to 8.
In these modes, the Pads are unassigned. Use the Learn function (Logic Express >
Preferences > Control Surfaces > Learn Assignment for xxx) to assign them to key
commands, for example.
Note: When in Learn mode: if a pad is pressed and released immediately, the learned
assignment does not work as expected.
To successfully assign a key command:
1 Enable the Learn New Assignment button in the Key Commands window.
2 Choose the desired key command, then press and hold the pad, until the Learn New
Assignment button switches to the “up” state.
This slightly different approach is due to messages sent by the Korg devices: when the
pad is immediately released, a value range is learned. Holding the pad until Learn
mode disengages, results in a fixed value being learned.
15 P l a y
16 Stop
Pad Assignment
Pad Assignment
1–8 Enables/disables Solo for the eight channels being controlled with the eight
channel strips.
9–16 Enables/disables Mute for the eight channels being controlled with the eight
channel strips.
Pad Assignment
1–8 Activates/deactivates the Record Enable button of the eight channels being
controlled with the eight channel strips.
9–16 Selects one of the eight channels being controlled with the eight channel strips.