8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
9
141
9 Korg microKONTROL and
KONTROL49
Setting Up Your Korg microKONTROL and KONTROL49
The section below outlines the steps required before you can use your control surface
with Logic Express.
To set up your control surface with Logic Express:
1 Ensure that your units are connected to the computer via USB.
2 Open Logic Express.
The units will be scanned for, and installed automatically. The microKONTROL/
KONTROL49 is automatically set to native mode—internal Scene settings are ignored.
Note: If installation and identification fails it may be possible that the microKONTROL/
KONTROL49 reaction time is too slow, due to USB bus-power issues. In this situation,
connect the supplied power adapter, and set the power switch to the DC position.
When you quit Logic Express (or delete the control surface icon in the Control Surface
Setup window), the microKONTROL/KONTROL49 is reset to normal (not native)
operation.