8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 7 JLCooper CS-32 MiniDesk 137
F Key Section
Cursor Section
Control Assignment
SHIFT Modifier for function of other controls. See SHIFT entries in left column.
F1 While held down, MUTE buttons 1–6 enable/disable automation of certain
parameters (see MUTE).
SHIFT Enables/Disables Cycle mode.
F2 While held down, MUTE buttons set automation mode to Read.
SHIFT Enables/Disables Autopunch mode.
F3 While held down, MUTE buttons set automation mode to Touch.
SHIFT Sets left locator to the current playhead position.
F4 While held down, MUTE buttons set automation mode to Latch.
SHIFT Sets right locator to the current playhead position.
F5 While held down, MUTE buttons set automation mode to Write.
SHIFT Sets punch in locator to the current playhead position.
F6
SHIFT Sets punch out locator to the current playhead position.
F7 Sets pots to Pan/Send mode (display shows “PA”).
SHIFT Enables/disables metronome click.
F8 Sets pots to Instrument Edit mode (display shows “In”).
F9 Sets pots to Effect Edit mode (display shows “P1”–“P9”).
Control Assignment
Up Zooms out vertically.
SHIFT In Effect Edit mode: moves up one Insert slot (unless top slot is selected).
Down Zooms in vertically.
SHIFT In Effect Edit mode: moves down one Insert slot (unless last slot is selected).
Left Zooms out horizontally.
SHIFT In Instrument and Effect Edit modes: decrements current parameter bank
(moves down one bank, or page, of parameters).
Right Zooms in horizontally.
SHIFT In Instrument and Effect Edit modes: increments current parameter bank
(moves up one bank, or page, of parameters).