8

Chapter 7 JLCooper CS-32 MiniDesk 135
Pan/Send Mode
Press F7 to enable Pan/Send mode (display shows “PA”). In this mode, the pots control
the following channel parameters:
While SHIFT is held down (display shows “AS”), the pots allow you to perform the
following assignments:
Instrument Edit Mode
Press F8 to enter Instrument Edit mode (display shows “In”). The pots control (software)
instrument parameters.
With SHIFT held down (display shows “b1”–“b9”), you can move between banks (pages)
of parameters (see “Cursor Section” on page 137).
Effect Edit Mode
Press F9 to enter Effect Edit mode (display shows “P1”–“P9”). The pots control the
parameters of the effect in the currently selected Insert slot.
With SHIFT held down (display shows “b1”–“b9”), you can switch between Insert slots,
and move between banks (pages) of parameters (see “Cursor Section” on page 137).
Control Assignment
SEND A/P1 Controls Send 1 level of selected channel.
SEND B/P2 Controls Send 2 level of selected channel.
PAN/P3 Controls pan of selected channel.
SEND C/P4 Controls Send 3 level of selected channel.
SEND D/P5 Controls Send 4 level of selected channel.
SEND E/P6 Controls Send 5 level of selected channel.
Control Assignment
SEND A/P1 Assigns Send 1 destination (bus) for selected channel.
SEND B/P2 Assigns Send 2 destination for selected channel.
PAN/P3 Assigns input format of selected channel.
SEND C/P4 Assigns Send 3 destination for selected channel.
SEND D/P5 Assigns Send 4 destination for selected channel.
SEND E/P6 Assigns Send 5 destination for selected channel.