8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
6
129
6 Frontier Design TranzPort
Setting Up Your Frontier Design TranzPort
The following section outlines the steps required to use your Frontier Design TranzPort
control surface with Logic Express.
To set up your Frontier Design TranzPort device in Logic Express:
1 Ensure that the software shipped with the TranzPort is installed.
2 Make sure that the Tranz Bridge (the wireless transmitter) is connected to the computer
via USB.
When Logic Express is opened, it installs the TranzPort automatically, and sets it to
native mode.
LCD
The LCD displays the following information:
 Top line left: Name of currently displayed channel
 Top line middle: Volume level of currently displayed channel
 Top line right: Pan position of currently displayed channel
 Bottom line left: Level meter of currently displayed channel
 Bottom line right: Current playhead position