8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 5 CM Labs Motormix 127
VIEW Section
Left Function Buttons
Control Assignment
Left/right buttons In Effect and Instrument Plug-in Edit modes: shifts the parameter bank.
In other modes:
 If BANK LED is off: shifts the fader bank by one channel.
 If BANK LED is on: shifts the fader bank by one bank (a group of 8
channels).
SHIFT In Effect and Instrument Plug-in Edit modes: shifts the parameter bank by
one parameter.
In Group Edit mode, the group parameter bank is shifted.
bank Switches mode of left/right buttons (see above).
SHIFT Sets Select buttons to Channel View mode.
group Sets Select buttons, rotary encoders, and Multi buttons to Group Edit mode.
SHIFT Displays channel group assignments in the LCD. The rotary encoders allow
you to change assignments.
Control Assignment
AUTO ENBL/mode Currently unassigned.
SHIFT Switches rotary encoders to Automation Enable mode.
SUSPEND/create While held down, the groups are temporarily disabled.
SHIFT Creates a new group, and enters Group Edit mode.
PLUG-IN/compare Switches rotary encoders and Multi buttons to Effect Assign mode. Use the
Rotary Select knob to choose the Insert slot that you want to edit.
In Effect or Instrument Assign mode, it switches to Pan mode.
In Effect Edit mode, it switches to Effect Assign mode.
In Instrument Edit mode, it switches to Instrument Assign mode.
SHIFT Switches rotary encoders and Multi buttons to Instrument Assign mode.
WINDOW/tools Switches Select buttons to Window Select mode.
SHIFT Switches Select buttons to Select Tool mode.
ALL/ALT/FINE While ALL/ALT/FINE is held down, rotary encoders are in full mode: rotating
counter-clockwise sets minimum, rotating clockwise sets maximum value.
SHIFT While SHIFT and ALL/ALT/FINE are held down, rotary encoders are in fine
mode. Parameter changes are made in single unit (or smaller) values.
DEFAULT/bypass Currently unassigned.
SHIFT In Instrument Edit mode: switches bypass state of the instrument.
In Effect Edit mode: switches bypass state of the effect being edited.
UNDO/save Performs an undo step. The LED is lit if there is a Redo step available.
SHIFT Saves the project. The LED is lit if the project contains unsaved changes.
SHIFT Switches to Shift mode—where the functions indicated by the (inverted)
labels below the buttons apply.