8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
126 Chapter 5 CM Labs Motormix
Burn Buttons
These buttons (labelled I to P) have multiple uses, depending on the current mode, as
indicated by the red LEDs to the left.
Note: In modal dialogs, the Burn buttons generate the computer keyboard character
shown on the button face.
SOLO Buttons
These buttons switch the Solo status of the displayed channel.
Note: In modal dialogs, the Solo buttons generate the computer keyboard character
shown on the button face.
MUTE Buttons
These buttons switch the Mute status of the displayed channel.
Note: In modal dialogs, the Mute buttons generate the computer keyboard character
shown on the button face.
Mode Assignment
record Enables/disables Record Enable status of channel.
SHIFT (fnctA) Switches automation mode to Latch.
ALL + SHIFT (fnctA) Switches automation mode of all channels to Latch.
write Switches automation mode to Write.
ALL Switches automation mode of all channels to Write.
SHIFT (fnctB) Switches automation mode to Read.
ALL + SHIFT (fnctA) Switches automation mode of all channels to Read.
burn Switches automation mode to Touch.
ALL Switches automation mode of all channels to Touch.
SHIFT (fnctC) Switches automation mode to Off.
ALL + SHIFT (fnctA) Switches automation mode of all channels to Off.