8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 4 M-Audio iControl 117
Play/Stop
Press the Play button (denoted by a right arrow) to start playback from the current
playhead position—or to stop playback—if the project is currently playing.
Fast Forward Button
Quickly press the Fast Forward button (denoted by two right arrows) to move the
playhead forward by one bar. Hold down the Fast Forward button to continuously
move the playhead forward in one bar increments.
You can also press the Fast Forward and Cycle buttons simultaneously—to activate
Cycle mode, and set the right cycle border (right locator) to the current playhead
position.
Cycle Button
Press the Cycle button (denoted by two circular arrows) to activate Cycle mode. If Cycle
mode is active, pressing the Cycle button deactivates it.
You can activate Cycle mode—and set the left and right cycle locators, respectively—
by using the Rewind or Fast Forward and Cycle buttons together.
To set the left and right locators, and activate Cycle mode:
1 Use the Jog Wheel to move the playhead to the desired left locator position, then press
both the Cycle and Rewind buttons.
2 Do one of the following:
 Navigate to the desired right locator position with the Jog Wheel, then press the
Cycle and Fast Forward buttons simultaneously.
 Hold down the Cycle button, navigate to the position where you want to set the
right locator using the Jog Wheel, then release the Cycle button.
Master Fader
Moving the Master fader on the iControl sets the level of the Master fader in the
Logic Express Mixer window. The Master fader changes the level of all output channels,
but does not affect the relative levels of these channels (that precede the Master fader
in the signal path). Move the fader left to decrease the master level, or to the right to
increase the master level.