8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Preface Introduction 11
Mackie Control Extender Mackie Mackie-badged version of the Logic Control XT.
As Logic Express also recognizes the Mackie
Control protocol, you may use any firmware
version. If you have firmware version 1.02 or
higher, you can freely use either the Logic Control
or Mackie Control mode. See “Mackie Control” on
page 61.
Mackie Control Universal Mackie A Mackie Control with Logic Control silk
screening (legend) and firmware version 2.0 or
higher (including HUI emulation). As
Logic Express also recognizes the Mackie Control
protocol, you can freely use either the Logic
Control or Mackie Control mode. See “Mackie
Control” on page 61.
microKONTROL Korg See “Korg microKONTROL and KONTROL49” on
page 141.
Motormix CM Labs See “CM Labs Motormix” on page 121.
Radikal Technologies SAC-2.2 The SAC-2.2/2k’s native mode is directly
supported, but it can also emulate a Mackie
Control. You should use the native mode.
See “Radikal Technologies SAC-2K” on page 177.
Radikal Technologies SAC-2k See “Radikal Technologies SAC-2K” on page 177.
SI-24 Roland See “Roland SI-24” on page 183.
TranzPort Frontier Design Group See “Frontier Design TranzPort” on page 129.
US-224 Tascam A stripped-down version of the US-428.
See “Tascam US-428 and US-224” on page 207.
US-2400 Tascam Logic Express supports the US-2400’s native
mode. In contrast to its Mackie Control mode, all
controls, including the joystick, are supported.
See section “Tascam US-2400” on page 199.
US-428 Tascam See “Tascam US-428 and US-224” on page 207.
Supported Devices Manufacturer Notes