9
Table Of Contents
- Logic Express 9 Effects
- Contents
- An Introduction to the Logic Express Effects
- Amps and Pedals
- Amp Designer
- Choosing an Amp Designer Model
- Tweed Combos
- Classic American Combos
- British Stacks
- British Combos
- British Alternatives
- Metal Stacks
- Additional Combos
- Building a Customized Amp Designer Combo
- Choosing an Amp Designer Amplifier
- Choosing an Amp Designer Cabinet
- Amp Designer Cabinet Reference Table
- Using Amp Designer’s Equalizer
- Amp Designer Equalizer Type Reference Table
- Using Amp Designer’s Gain, Presence, and Master Controls
- Getting to Know Amp Designer’s Effects Parameters
- Using Amp Designer’s Reverb Effect
- Amp Designer Reverb Type Reference Table
- Using Amp Designer’s Tremolo and Vibrato Effects
- Setting Amp Designer Microphone Parameters
- Setting Amp Designer’s Output Level
- Bass Amp
- Guitar Amp Pro
- Building Your Guitar Amp Pro Model
- Choosing a Guitar Amp Pro Amplifier
- Choosing a Guitar Amp Pro Speaker Cabinet
- Choosing a Guitar Amp Pro Equalizer
- Using Guitar Amp Pro’s Gain, Tone, Presence, and Master Controls
- Getting to Know Guitar Amp Pro’s Effects Section
- Using Guitar Amp Pro’s Tremolo and Vibrato Effects
- Using Guitar Amp Pro’s Reverb Effect
- Setting Guitar Amp Pro Microphone Parameters
- Setting the Guitar Amp Pro Output Level
- Pedalboard
- Amp Designer
- Delay Effects
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- AutoFilter
- EVOC 20 Filterbank
- EVOC 20 TrackOscillator
- What Is a Vocoder?
- How Does a Vocoder Work?
- Getting to Know the EVOC 20 TrackOscillator Interface
- EVOC 20 TrackOscillator Analysis In Parameters
- Using EVOC 20 TrackOscillator Analysis In Parameters
- EVOC 20 TrackOscillator U/V Detection Parameters
- EVOC 20 TrackOscillator Synthesis In Parameters
- Basic Tracking Oscillator Parameters
- Tracking Oscillator Pitch Correction Parameters
- Quantizing the Pitch of the Tracking Oscillator
- EVOC 20 TrackOscillator Formant Filter Parameters
- Using Formant Stretch and Formant Shift
- EVOC 20 TrackOscillator Modulation Parameters
- EVOC 20 TrackOscillator Output Parameters
- Fuzz-Wah
- Spectral Gate
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Specialized Effects and Utilities
- Utilities and Tools
AutoFilter Threshold Parameter
The Threshold parameter analyzes the level of the input signal. If the input signal level
exceeds the set threshold level, the envelope and LFO are retriggered—this applies only
if the Retrigger button is active.
The envelope and LFO can be used to modulate the filter cutoff frequency.
AutoFilter Envelope Parameters
The envelope is used to shape the filter cutoff over time. When the input signal exceeds
the set threshold level, the envelope is triggered.
• Attack knob and field: Sets the attack time for the envelope.
• Decay knob and field: Sets the decay time for the envelope.
• Sustain knob and field: Sets the sustain time for the envelope. If the input signal falls
below the threshold level before the envelope sustain phase, the release phase is
triggered.
• Release knob and field: Sets the release time for the envelope (this is triggered as soon
as the input signal falls below the threshold).
• Dynamic knob and field: Determines the input signal modulation amount. You can
modulate the peak value of the envelope section by varying this control.
• Cutoff Mod. slider and field: Determines the impact of the envelope on the cutoff
frequency.
99Chapter 6 Filter Effects