8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
84 Chapter 6 Filter
 Level slider: Controls the amount of the signal (Noise, Noise + Synth, or Blend) used
to replace the unvoiced content of the input signal.
Output Section
 Signal pop-up menu: Choose the signal to send to the EVOC 20 TrackOscillator’s main
outputs. The choices are: Voc(oder), Syn(thesis), and Ana(lysis). To hear the vocoder
effect, choose Voc. The other two settings are useful for monitoring purposes.
 Level slider: Sets the level of the output signal.
 Stereo Mode pop-up menu: Sets the input/output mode of the EVOC 20 Filterbank.
The choices are m/s (mono input to stereo output), and s/s (stereo input to stereo
output).
Set Stereo Mode to m/s if the input signal is mono, and to s/s if the input signal is
stereo. In s/s mode, the left and right stereo channels are processed by separate filter
banks. When using m/s mode on a stereo input signal, the signal is first summed to
mono before it is passed to the filter banks.
Warning: Care should be taken with this control, particularly when a high Sensitivity
value is used, to avoid internally overloading the EVOC 20 TrackOscillator.