8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
80 Chapter 6 Filter
 Click the value below the word Scale to display the Root/Scale pop-up menu.
 Choose the scale or chord to use as the basis for pitch correction from the pop-up
menu.
 Set the root key of the respective scale or chord by vertically dragging the Root
parameter, or double-click and enter a root between C and B. The Root parameter
is not available when the Root/Scale value is chromatic or user.
 You can add notes to the chosen scale or chord by clicking keys on the small
keyboard, and remove notes by clicking notes already selected. Selected notes
appear bright green. Selecting any notes sets the Root/Scale value to user.
 Your last edit is remembered. If you choose a new scale or chord, but do not make
any changes, you can jump back to the previously set user scale.
You can automate the Root and Scale parameters and the keys of the onscreen
keyboard in Logic Express.
 Max Track value field: Sets the frequency above which the high frequencies of the
analysis signal are cut, making the pitch detection more robust. Should the pitch
detection produce unstable results, reduce the Max Track parameter value to the
lowest possible setting.
Formant Filter Section
The parameters in section control the two formant filter banks of the
EVOC 20 TrackOscillator.
 Formant Filter graphic display: Shows the frequency bands for the analysis and
synthesis parameters.
The Formant Filter display is divided into two sections by a horizontal line. The upper
half applies to the Analysis section and the lower half to the Synthesis section.
Changes made to the High/Low frequency parameters, the Bands parameter or the
Formant Stretch and Formant Shift parameters will result in visual changes to the
Formant Filter display. This provides you with invaluable feedback on what is
happening to the signal as it is routed through the two formant filter banks.