8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
74 Chapter 6 Filter
Output Section
The parameters in this section control the overall output of the EVOC 20 Filterbank.
 Overdrive button: Turns the overdrive circuit on or off.
Note: To hear the Overdrive effect, you may need to boost the level of one or both
filter banks.
 Level slider: Sets the level of the output signal.
Stereo Mode pop-up menu: Sets the input/output mode of the EVOC 20 Filterbank.
The choices are m/s (mono input to stereo output), and s/s (stereo input to stereo
output).
Set Stereo Mode to m/s if the input signal is mono, and to s/s if the input signal is
stereo. In s/s mode, the left and right stereo channels are processed by separate filter
banks. When using m/s mode on a stereo input signal, the signal is first summed to
mono before it is passed to the filter banks.
 Stereo Width knob: Controls how the output signals of the filter bands are distributed
in the stereo field.
 At the left position, the output of all bands are centered.
 At the centered position, the output of all bands ascends from left to right.
Â
At the right position, the bands are output evenly on the left and the right channel
.
The stereo/stereo mode (s/s) uses one A/B filter bank per channel. The positioning of
the frequency bands correspond to that described above, but the bands of each filter
bank ascend in opposing directions, from left to right.