8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
38 Chapter 4 Dynamics
 Compression Threshold slider and field: Sets the threshold for the Compressor (the
level above which the signal is reduced).
 Peak/RMS buttons: Turn on one or the other to set whether the Compressor analyzes
the signal using Peak or RMS method when using the Platinum Circuit Type.
 Gain slider and field: Sets the amount of gain applied to the output signal.
 Gain pop-up menu: Choose a value to raise the output level in order to compensate
for volume reduction caused by compression. The choices are OFF, 0 dB, and –12 dB.
 Limiter Threshold slider and field: Sets the threshold level for the limiter.
 Limiter button: Turns the integrated limiter on or off.
Extended Parameters
 Output Distortion pop-up menu: Choose whether to apply clipping above 0 dB, and
what type of clipping is applied. The values are off, soft, hard, and clip.
 Mix slider and field: Determines the balance of dry and wet signals.
Side Chain Filter
 Activity pop-up menu: Choose whether the Compressor side chain is turned on or off,
or in listen (audition) mode. The choices are off, listen, and on.
 Mode pop-up menu: Choose the type of filter used for the side chain. The choices are
BP (bandpass), LP (lowpass), HP (highpass), ParEQ (parametric), and HS (high
shelving).
 Frequency slider and field: Sets the frequency for the side chain filter.
 Q slider and field: Sets the bandwidth of the frequency band affected by the side
chain filter.
 Gain slider and field: Sets the amount of gain applied to the side chain signal.