8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
368 Chapter 24 Ultrabeat
Output Section
Depending on the status of each filter bypass button, the output signals of both
oscillators, the ring modulator and the noise generator are routed either; directly or via
the Filter section to the Output section of Ultrabeat. The Output section passes signals
through both equalizers (EQ) and the Pan Modulation and Stereo Spread section (in a
pre-configured order) before the final level is set, and the trigger behavior (of the
signals) is adjusted.
Two Band EQ
Both equalizer bands have almost identical features. Their parameters are explained
jointly, but you can, of course, adjust band 1 (the upper EQ in the Output section) and
band 2 separately.
Clicking on the Band 1 and Band 2 labels turns the individual band on or off. When
active, the field is red. If neither EQ is activated, the signal passes through unaffected.
The EQ type buttons switch between two different types of EQs: shelving and peak.
In shelving mode, all frequencies above or below the set frequency are either increased
or reduced. In peak mode, only frequencies located near the set frequency are affected.
The shelving EQ is activated by clicking the upper of the two EQ type buttons. The
peak EQ is activated by clicking the lower of the two EQ type buttons.
Band 1 offers a low shelving EQ while band 2 features a high shelving EQ. Low shelving
means that the frequencies below the set frequency are affected. High shelving affects
frequencies above the set frequency.
Note: Shelving EQs function similarly to synthesizer lowpass and highpass filters. The
fundamental difference: while lowpass and highpass filters merely dampen certain
frequencies (filter them out), shelving EQs also allow these frequencies to be boosted.