8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
310 Chapter 21 EXS24 mkII
EXS24 mkI Modulation Paths
Many of the hard-wired modulation paths that were available as sliders on the original
EXS24 (mkI) are part of the modulation matrix. In order to reconstitute the modulation
slider configuration of the mkI version, click on the “options” button in the upper-right
corner and choose (Recall default EXS24 mkI settings) from the pop-up menu. This will
load the mkI modulation paths into the modulation matrix, as follows:
 Velocity to Sample Select
 LFO 1 to Pitch via ModWheel (= Ctrl#1)
 Velocity to Sample Start (inv)
 LFO 2 to Filter Cutoff via ModWheel
 Velocity to Filter Cutoff
 Envelope 1 to Filter Cutoff via Velocity
 LFO 2 to Pan via ModWheel
You can, of course, freely alter the settings of these modulation paths. To exchange
modulation sources with sources that were not available in EXS24 mkI, for example (see
the complete list of sources and destinations below).
Note: For technical reasons, the settings of the modulation matrix can not translate
backwards to the EXS24 mkI.
Available Modulation Sources and Destinations
The following modulation sources and destinations are available in the EXS24 mkII.
Modulation Sources:
 Side Chain (level)
 Maximum
 Env 1
 Env 2 (Amp)
 LFO 1, LFO2, and LFO 3
 Release Velocity
 Pressure
 Pitch Bend
 Key
 Velocity
 Control Nr. 1 to Control Nr. 120