8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
Chapter 2 Delay 23
Stereo Delay
The Stereo Delay works much like the Tape Delay (see below), but allows you to set the
Delay, Feedback, and Mix parameters separately for the left and right channel.
The effect also features a Crossfeed knob for each stereo side. It determines the
feedback intensity—or the level at which each signal is routed to the opposite stereo
side.
You can freely use the Stereo Delay on mono tracks or busses, when you want to create
independent delays for the two stereo sides.
Note: If you do use the effect on mono channel strips, the track or bus will have two
channels from the point of insertion (all Insert slots after the chosen slot will be stereo).
This section only covers the additional features offered by the Stereo Delay. For more
information about the parameters shared with the Tape Delay, see the Tape Delay
section below.
 Left Input and Right Input: Use these to choose the input signal for the two stereo
sides. Options include Off, Left, Right, L+R, L-R.
 Feedback Phase button: Use to invert the phase of the corresponding channel’s
feedback signal.
 Crossfeed Left to Right and Crossfeed Right to Left: Use to transfer the feedback signal
of the left channel to the right channel, and vice versa.
 Crossfeed Phase buttons: Use to invert the phase of the crossfed feedback signals.