8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
202 Chapter 20 ES2
Osc Start
The oscillators can run freely, or they can begin at the same phase position of their
waveform cycle each time you hit a key (every time the ES2 receives a note on
message).
 When Osc Start (Oscillator Start) is set to free, the initial oscillator phase startpoint is
random, with each note played. This gives the sound more life and a less static feel—
just like an analog hardware synthesizer. On the other hand, the output level may
differ each time you play a note, and the attack phase may sound less punchy.
 If you set Osc Start to soft, each initial oscillator phase will start at a zero crossing
every time a note is played. This mimics the sonic character of a normal digital
synthesizer.
 If Osc Start is set to hard, each initial oscillator phase begins at the highest possible
level in its waveform cycle every time a note is played. This punch is only audible if
the ENV3 Attack Time is set to a minimal value—a very fast attack. This setting is
highly recommended for electronic percussion and hard basses.
Note: Osc Start soft and hard result in a constant output level of the initial oscillator
phase every time the sound is played back. This may be of particular importance when
using the Bounce function of Logic Express, at close to maximum recording levels.