8

18 Chapter 1 Amp Modeling
 Gain knob: Sets the amount of pre-amplification applied to the input signal. This
control has different effects, dependent on which Amp model is selected. For
example, when using the British Clean amp model, the maximum Gain setting
produces a powerful crunch sound. When using the British Gain or Modern Gain
amps, the same Gain setting produces heavy distortion, suitable for lead solos.
 Bass, Mids, and Treble knobs: Adjusts the frequency ranges of the EQ models, similar
to the tone knobs on a hardware guitar amplifier.
 Presence knob: Adjusts the high frequency range. The Presence parameter affects
only the output (Master) stage of Guitar Amp Pro.
 Master knob: Sets the output volume of the amplifier (going to the speaker).
Typically, for tube amplifiers, increasing the Master level produces a more
compressed and saturated sound, resulting in a more distorted and powerful (louder)
signal. High settings can produce an extremely loud output. In Guitar Amp Pro, the
Master parameter modifies the sonic character, and the final output level is set using
the Output parameter below the FX section. (see below for information).
Effects Section
The Effects section contains Reverb, Tremolo, and Vibrato effects. You can choose either
Tremolo (which modulates the amplitude or volume of the sound) or Vibrato (which
modulates the pitch), and use Reverb together with either one, or separately.
Before you can use or adjust an effect, you must first turn it on by clicking its On button
(with a power on icon). The On button lights when the effect is turned on. The FX and
Reverb On buttons are located to the left of the controls for each effect.
Note: The Effects section is placed before the Master control in the signal flow, and
therefore receives the pre-amplified (pre-Master) signal.
FX Parameters
 FX pop-up menu: Choose either Tremolo or Vibrato from the menu.
 Depth knob: Sets the intensity of the modulation.
 Speed knob: Sets the speed of the modulation (in Hz). Lower settings produce a
smooth and floating sound, while higher settings produce a rotor-like effect.
 Sync button: When turned on, the Speed is synchronized to the project tempo. When
Sync is activate, adjusting the Speed parameter lets you select different musical note
values. Set the Speed parameter to the desired value, and whichever effect you have
chosen will be perfectly synchronized to the project tempo.
Reverb Parameters
 Reverb pop-up menu: Choose one of the three types of spring reverb.
 Level knob: Sets the amount of reverb applied to the pre-amplified amp signal.