8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
164 Chapter 14 EVOC 20 PolySynth
Intensity and Int via Whl
The Intensity slider controls the amount of Formant Shift modulation by the Shift LFO.
The Int via Whl slider for the Pitch LFO features a multi-part slider. The intensity of LFO
pitch modulation can be controlled by the modulation wheel of an attached MIDI
keyboard. The upper half of the slider determines the intensity when the modulation
wheel is set to its maximum value, and the lower half when set to its minimum value.
By clicking and dragging in the area between the two slider segments, you can
simultaneously move both.
Rate Knobs
These knobs determine the speed of modulation. Values to the left of the center
positions are synchronized with the sequencer’s tempo and include bar values, triplet
values, and more. Values to the right of the center positions are non-synchronous, and
are displayed in Hertz (cycles per second).
Note: The ability to use synchronous bar values could be used to perform a formant
shift every four bars on a cycled one bar percussion part. Alternately, you could
perform the same formant shift on every eighth note triplet within the same part.
Either method can generate interesting results, and can lead to new ideas, or a new
lease of life on old audio material.