8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
Chapter 14 EVOC 20 PolySynth 157
Dual Mode Parameters
The parameters specific to Dual mode are found in the Wave 2 section, and the Balance
slider to the right.
 Semi parameter: Adjusts the tuning of the second oscillator (Wave 2) in semitone steps.
 Detune parameter: Fine-tunes Wave 1 and Wave 2 in cents. 100 cents equals a
semitone step. Doing so will detune Wave 1 in conjunction with Wave 2 around the
tuning zero point.
 Balance slider: Allows you to blend the two oscillator signals (Wave 1 and Wave 2).
FM Mode Parameters
The parameters specific to the FM mode are found in the Wave 2 section, and the FM
Int slider to the right.
 Ratio c(oarse) parameter: Adjusts the coarse frequency ratio of the second oscillator
in relation to the first oscillator.
 Ratio f(ine) parameter: Adjusts the fine frequency ratio of the second oscillator in
relation to the first oscillator.
 FM Int slider: Determines the intensity of Wave 1’s sine wave modulation by Wave 2.
Higher FM Int settings will result in a more complex waveform with more overtones.
When combined, the Ratio and FM Int parameters form the resulting complex FM
waveform, thus defining the harmonic content.