8
Table Of Contents
- Logic Express 8 Instruments and Effects
- Contents
- Introduction to the Logic Express Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
Chapter 9 Modulation 111
 Wood & Horn IR: This setting uses an impulse response (a recording) of a Leslie with a
wooden enclosure.
 Proline & Horn IR: This setting uses an impulse response of a Leslie with a more open
enclosure.
 Split & Horn IR: This setting uses an impulse response of a Leslie with the bass rotor
signal routed more to the left side, and the treble rotor signal routed more to the
right side.
Choosing a Motor Control Mode
In the Motor Control menu, you can set different speeds for the bass and treble rotors:
 Normal: Both rotors use the speed set by the rotor speed buttons.
 Inv (inverse mode): In Tremolo mode, the bass compartment rotates at a fast speed,
while the horn compartment rotates slowly. This is reversed in Chorale mode. In
Brake mode, both rotors will stop.
 910: The 910, or Memphis mode, stops the bass drum rotation at slow speed, while
the speed of the horn compartment can be switched. This may be desirable, if you’re
after a solid bass sound, but still want treble movement.
 Sync: The acceleration and deceleration of the horn and bass drum are roughly the
same. This sounds as if the two are synchronized, but is only clearly audible during
acceleration or deceleration.
Note: If you choose Single Cabinet in the Cabinet Type menu, the Motor Ctrl setting is
irrelevant, because there are no separate bass and treble rotors in a Single Cabinet.