9

All parameters that you choose to automate will appear in the pop-up menu at the top
of the (parameter) offset row. Click the grid header (left of the zero axis) to open the
menu.
Note: The simple act of moving a control element in the Synthesizer section will add the
parameter to the offset menu, so take care.
Using Ultrabeat’s (Parameter) Offset Row
This row enables you to view and enter offset values—on a per-step basis—for any of
the Synthesizer section parameters that can be automated.
Parameter edits can be made in three ways:
• By directly adjusting the controls in the Synthesizer section
• By editing offset values in the offset row
• With the shortcut menu (see Using Ultrabeat’s Parameter Offset Shortcut Menu
Commands)
Note: Adjustments made in the offset row are relative to the current parameter value.
Values shown in the offset row will be either added to, or subtracted from, the parameter
value set in the Synthesizer section. In other words, parameter offsets increase or
decrease—but do not specify—an absolute value for the parameter.
To create a parameter offset
1 Select the desired sound.
2 Click a position in the (parameter) offset row that corresponds to the step you want to
edit.
3 Make the desired parameter changes in the Synthesizer section. Your changes will be
recorded as an offset value for this step.
4 Repeat step 3 for each parameter that you want to edit for this step.
299Chapter 11 Ultrabeat