Installation guide

MC Installation Guide4
When a Workstation key is pressed, the MC sends a switch
command to the KVM and changes your display to reflect that
KVM input.
Configuring DAW Software for the MC
After connecting your MC to your workstation. Proceed to the
chapter of this installation guide for your DAW software to
configure it to work with the MC.
Since the MC does not know the order your workstations
were connected to the KVM, we recommend assigning the
workstation attached to KVM input 1 to Workstation key
1, the workstation attached to KVM input 2 to Workstation
key 2, etc. Otherwise the MC will not control the desired
workstation when the display is switched.
If your MC did not connect properly, or a step failed, see
Appendix A, “Troubleshooting.”