Specifications

12.Slide the logic board back in.

Push on the edge of the logic board until it is finally in place.

13.If there is a connector on the card that you just

installed (for example, if you are installing an Apple IIe

Card), remove the access cover on the back panel you

removed earlier.

Pinch together the plastic tabs on the access cover to remove

it and pop it out. With the access cover off, you can use the

port on the card you just installed.

14.Replace the back panel of the computer.

Slip the back cover over the prongs at the bottom edge of the

back of the computer. If your back panel was held on by

screws, replace them.

s Warning: Never turn on your computer unless all of its

internal and external parts are in place. Operating the

computer when it is open or missing parts can be dangerous,

and can damage your computer.