Specifications

Flowcharts and TablesTroubleshooting
No
Go to Flowchart 2.
Does the
Ready/In Use LED
glow steadily after
warmup?
Yes
Run the LaserWriter Select 360 printer diagnostic (see "Printer Diagnostics"
section). Replace modules as indicated in the "Printer Diagnostics" section.
If no specific error is indicated during the diagnostic, switch off the printer,
jumper the pins at JMP1 on the I/O controller, and return the mode switch
to its original setting.
Open the File menu and choose Print Window or Print Directory.
No
Does the
printer print
from a
Macintosh?
Yes
No
Is the
print quality
OK?
Yes
Go to "Print Quality
Problems."
1. Place paper on the manual feed tray.
2. Open the File menu and choose Print Window or Print Directory.
3. Select Manual Feed as the paper source in the Print dialog box.
No
Yes
Go to Table 30,
No Paper Pickup From
Manual Feed or
Multipurpose Tray.
Does the
printer deliver
a manually fed
page?
The printer is fully functional.
Go to Table 7 or 8,
depending on the specific
I/O board error.
START
LaserWriter Select 360 Flowchart 1