User`s guide

Take Apart High-Voltage Connector Block - 111
1 Remove the screw that secures the right cassettte guide
to the fuser end of the printer.
2 Note: The tab referenced in the following step is
accessible from behind the rear wall of the chassis.
Release the single flex tab with your finger and shimmy
the cassette guide off the printer.
3 Disconnect J210 (the orange cabling) from the DC
controller board.
4 Release the expansion posts behind the receptacle that is
anchored into the chassis wall, detach the receptacle, and
push the receptacle back through the chassis opening.
5 Release the flex tab near the cable tie and receptacle and
remove the connector block from the printer.