User`s guide

Take Apart DC Controller Board - 98
1 Disconnect J103 from the power supply.
2 Remove the all cables except for the engine interface
cable and power supply connector TB201.
Note: Do not attempt to remove connector TB201 from
the DC controller board. Connector TB201 is hard-
wired to the board.
3 Release the two flex tabs and pull the board out of the
printer.
Replacement Note: Set the bottom edge of the board into
the two mounts and then snap the top into place. Make
sure that the positioning posts line up with the holes in
the board.
Note: Perform the “Registration Adjustment”
procedure (see Additional Procedures).