Technical information

19 Click OK.
The PostScript Printer Setup window appears.
20 Click OK.
Installation is complete.
21 Choose how to proceed:
For users connected via the parallel cable, the default printer driver settings
should suffice.
For instructions on using the Apple LaserWriter Utility for Windows, see
Appendix A.
To configure your printer software with NetWare, see “Initial Novell NetWare
4.1 Setup,” later in this chapter.
Installing on a Windows 3.1 computer
1 Find the Windows disks containing the printer software and make sure they’re
write-protected.
Slide up the write-protection tab in one corner of the floppy disk so that you
can see through the hole.
2 Start Windows.
Before installing the software, make sure the Windows control panel and
Printers folder are closed.
3 Insert LaserWriter Disk 1 for Windows 3.1 into a floppy disk drive.
4From the Windows Program Manager, choose Run from the File menu.
5Type A:\SETUP or B:\SETUP (depending on which drive holds your installation
disk) in the command line field and click OK.
After a few moments, a message appears telling you to close all other
applications before continuing with this installation.
6Click Continue if no other applications are open.
If you have open applications, click Exit to stop this installation. Close all
other applications and start the installation process again.
The software license agreement appears.
67
Setting Up the Printer for Windows, DOS, and NetWare Users