Technical information

24 When you’re done, click Exit.

Installation is complete.

25 Choose how to proceed:

For users connected via the parallel cable, the default printer driver settings

should suffice.

To configure your printer software for TCP/IP, see “Initial TCP/IP Setup for

Windows 95 and Windows NT” later in this chapter.

For instructions on using the Apple LaserWriter Utility for Windows, see

Appendix A.

To configure your printer software with NetWare, see “Initial Novell NetWare

4.1 Setup,” later in this chapter.

Installing on a Windows NT 4.0 computer

1 Find the Windows disks containing the printer software and make sure they’re write-

protected.

Slide up the write-protection tab in one corner of the floppy disk so that you

can see through the hole.

2 Start Windows NT.

Before installing the software, make sure the Windows control panel and

Printer folder are closed.

3Insert

LaserWriter Disk 1 for Windows NT

into a floppy disk drive.

Note: If you are installing from disks made from the CD, the floppy disk

labels may be different.

4Click the Start Icon on the Task-Bar and select Run.

5Type

A:\SETUP

B:\SETUP

(depending on which drive holds your installation

disk) in the command line field and click OK.

After a few moments, a message appears warning you to close all other

applications before continuing with this installation.

Chapter 3