Technical information

11 Click Next.

The Properties dialog box appears.

Note: If you are using the printer on a network, select the PostScript tab, then

select Advanced. Deselect the “Send CTRL+D after job” option.

12 Click OK to dismiss the Properties dialog box.

A message appears telling you that the driver software was successfully

installed.

13 Click Add Another to install another Apple LaserWriter printer.

Repeat for each printer you want to install.

14 When you’re done, click Exit.

Installation is complete.

15 Choose how to proceed:

To configure your printer software for TCP/IP, see “Initial TCP/IP Setup for

Windows 95 and Windows NT,” later in this chapter.

For users connected via the parallel cable, the default printer driver settings

should suffice.

For instructions on using the Apple LaserWriter Utility for Windows, see

Appendix A.

To configure your printer software with NetWare, see “Initial Novell NetWare

4.1 Setup,” later in this chapter.

Chapter 3