Technical information

Communication settings
The following table shows the default communication settings. For
information about using the communication switch to adjust communication
settings, see “Adjusting Communication Settings” in Chapter 1. To change or
view the current communication settings, use the Apple Printer Utility for
Mac OS computers (see Appendix A) or the Apple LaserWriter Utility for
Windows on IBM PC or compatible computers (see Appendix A).
Normal (in) switch position
These settings can be changed to the following modes:
Port Protocol Mode
LocalTalk LocalTalk PostScript, Off
Ethernet EtherTalk PostScript, Off
NetWare PostScript, Off
TCP/IP PostScript, Off
Parallel TBCP PostScript, Off
Reset (out) switch position
When the communication switch is in the Reset (out) position, the following
values are used:
Port Protocol Mode
LocalTalk LocalTalk PostScript
Ethernet EtherTalk PostScript
NetWare PostScript
TCP/IP PostScript
Parallel TBCP PostScript
Note: When the communication switch is in the Reset (out) position, a
startup page is printed each time the printer is turned on and the Extended
Job Status settings are removed.
273
Technical Information