Technical information

6Click OK.
A page prints confirming the choice.
Printing a list or samples of printer fonts
You can print a list or samples of the PostScript fonts currently stored in the
printer’s memory or attached hard disk.
1Choose Print PostScript Fonts from the File menu.
2Click Print Font Catalog or Print Font Samples.
PostScript font samples or a list of PostScript fonts are printed.
Viewing or changing communication settings
The standard communication settings of the printer work for most
environments. To make sure the printer is set up to use the standard settings,
check that the communication switch on the left side of the printer is in the
Normal (in) position. The switch is located below the interface connectors.
You can view and change the standard communication settings for the printer
with the Apple LaserWriter Utility.
You make changes to the communication settings with the printer’s
communication switch set in the Normal (in) position. This makes all
communication settings available for changes.
For more information about connecting the printer to LocalTalk, Ethernet,
and parallel ports, see “Connecting the Printer” in Chapter 1. For more
information about setting the communication switch on the printer, see
“Adj u s t i ng Communication Settings” in Chapter 1.
1Choose Configure Port from the Utilities menu.
2Choose the port settings you want.
m You can set the Parallel interface to PostScript mode, TBCP, or No Change.
m You can set the LocalTalk interface to PostScript mode or turn it off.
m You can set the EtherTalk interface to PostScript mode or turn it off.
m You can set the NetWare interface to PostScript mode or turn it off.
m You can set the TCP/IP interface to PostScript mode or turn it off.
246
Appendix A