Technical information

m To co nnect the printer between two devices on an Ethernet network,
disconnect one Ethernet cable from the transceiver of the device
immediately to the left or right of the printer and plug it into the new
printer’s transceiver. Then use the new Ethernet cable to connect the free
socket on the printer’s transceiver to the socket you freed on the other
device’s transceiver.
m To co nnect the printer to an Ethernet hub, see the documentation that came
with the Ethernet hub.
What to do after connecting to an Ethernet network
m If you wish to connect the printer directly to a Windows or DOS computer,
see the next section.
m If you’re finished connecting the printer, skip to “Adjusting Communication
Settings,” later in this chapter.
See Chapters 2, 3, and 4 for more information about setting up the printer for
different network interfaces.
24
Chapter 1