Technical information

2 Open the TCP/IP Configuration category.
A panel appears in which you can enter the IP address.
3Enter the IP address.
4 Drag the slider to set the printer’s subnet mask.
5Enter the Default Gateway Address.
6Click Send to send the TCP/IP configuration to the printer.
Viewing and changing the communication settings
The standard communication settings of the printer work for most
environments. To make sure the printer is set up to use the standard settings,
check that the communication switch on the left side of the printer is in the
Normal (in) position. The switch is located below the interface connectors.
You can view and change the standard communication settings for the printer
with the Apple Printer Utility. The NetWare, TCP/IP, and Parallel interfaces
are set to PostScript.
238
Appendix A
Type the IP address here.
IP address of the default
gateway used for sending
packets off the local network.
Drag the slider to
change the printer’s
subnet mask.
You can drag the
slider only if the
printer’s IP address
is not 0.0.0.0.