Technical information

Logging in to the TCP/IP Printer Configuration Utility
To run the utility, follow these steps:
1 Use telnet to log in to the printer’s TCP/IP Printer Configuration Utility by typing
telnet printer_IP_name
The printer responds by displaying a message on your screen welcoming you
to the Configuration Utility.
2Enter a password.
The first time you log in to the printer, it requires you to assign a password
to the utility. The password must be between five and ten characters long. The
characters you type do not appear on the screen.
Subsequently, you enter the password to use the utility. The characters you
type do not appear on the screen.
Note: You can change the password using this utility, as explained later in
this chapter.
Printing the configuration page
The configuration page shows setup information for the printer itself and for
all of the network interfaces.
1 Go to the main menu of the TCP/IP Printer Configuration Utility.
2Type 1 and press Enter.
Displaying information about the printer’s TCP/IP interface
To see information displayed on your screen about the printer’s TCP/IP
interface, follow these steps:
1 Go to the main menu of the TCP/IP Printer Configuration Utility.
2Type 2 and press Enter.
104
Chapter 4