User`s manual

If your MS-DOS application program does not allow you to insert the Control-D character at the
end of your file, the LaserWriter II does not immediately print the last page of a document
unless the page is full or ends with a form feed (end-of-page) character. Instead, the page is
printed as part of the next document (at the top of the first page). When you're printing
documents in close succession, make sure that each one has a final form feed, so they won't run
together. If no other document is ready to print, the LaserWriter IIntx waits for thirty
seconds-after last receiving data-before it prints the last page.
The following Diablo 630 features are not recognized by the LaserWriter II:
print suppression
HY-plot
extended character set
the ability to download information for print wheels, including program mode
the ability to override print wheel spacing (for proportional spacing), although the
offset between characters can be changed
page lengths other than 11 inches
paper feeder control
hammer energy control
remote diagnostic
reverse printing
___________________________________________________________
LaserJet+ emulation
The Hewlett-Packard LaserJet+ emulation mode of the LaserWriter IIntx uses the 25-pin
connector. In this mode you can print text and bitmapped graphics, using the LaserJet's font
selection and positioning commands.
To set your LaserWriter IIntx for LaserJet+ emulation, place switches 2, 3, and 4 in the down
position.
Install the LaserJet+ printer driver on your MS-DOS computer, following the instructions in
the manual that came with your application program. You can then print documents as if the
LaserWriter IIntx were a LaserJet+ printer.
The LaserWriter IIntx interprets the Control-D key combination as an end-of-file command. If
you can, insert the Control-D character at the end of your file. When the printer receives the
Control-D character, it immediately prints the last page in your document.
If your MS-DOS application program does not allow you to insert the Control-D character at the
end of your file, the LaserWriter IIntx does not immediately print the last page of a document
unless the page is full or ends with a form feed (end-of-page) character. Instead, the page is
printed as part of the next document (at the top of the first page). When you're printing
documents in close succession, make sure that each one has a final form feed, so they won't run
together. If no other document is ready to print, the LaserWriter IIntx waits for 30 seconds-
after last receiving data-before it prints the last page.
The LaserJet+ emulator of the LaserWriter IIntx allows you to print just about anything you
could print on the LaserJet+, but there are a few minor differences: