User`s manual

1. Open the Control Panel. See your Apple II owner's guide for detailed instructions.
2. Choose Slots from the Control Panel menu.
3. Set slot 1 (Printer Port) to Your Card.
If you connected the printer to the modem port instead, configure slot 2 to Your Card. This
procedure prevents any conflict with step 4.
4. Set slot 7 (Your Card) to Built-in AppleTalk.
Although the LaserWriter II is physically connected to slot 1 or slot 2, the computer now acts
as though the printer were connected to slot 7.
___________________________________________________________
Using the Namer
If you're adding a LaserWriter II to an existing network, you'll find it convenient to give it a
distinguishing name. If you have only one printer, you don't need to name it unless you want to.
If you're adding an Apple II, rather than a printer, to the network, you should use the name the
printer already has. It will be listed in the Chooser by that name.
1. Turn on the printer you want to name.
2. Start up the Apple II with the workstation disk.
3. Select the Printer Namer application from the menu. This opens the application.
4. Choose the printer type you want to name. You'll see a list of printers of this type on the
right side of the dialog box.
5. Choose a printer from the list on the right. The printer name automatically moves to the New
Name box.
6. Type in a new name or edit the current name.
7. Click Accept.
8. Click Quit.
___________________________________________________________
Important-If you change the name of any printer, be sure to tell everyone else who uses the
network. You won't have to use the Namer again unless you want to change a printer's name.
___________________________________________________________
Using the Chooser
The Chooser allows you to designate which network printer you want to use. Once you designate a
printer, your choice is recorded on the system disk. You shouldn't have to use the Chooser again
unless you want to change printers or unless you are the first person to use a network printer
after it is turned off and then on again.
1. Start up the Apple II with the workstation disk.
2. Select Chooser from the Main Menu.
3. Choose LaserWriter as the printer type.
4. If necessary, choose the correct AppleTalk zone.
If your network is subdivided into several AppleTalk zones, choose the zone your printer
belongs to by clicking its name.
5. Choose the printer you want to use.