User`s manual

the instruction guide packaged with the toner cartridge.
___________________________________________________________
1. Open the cartridge box.
Open the cartridge shipping carton, take out the wrapped cleaning pad, and put it aside. Open the
sealed metallic bag and remove the cartridge, holding it by the indentation at its wide end (the
end without the writing).
2. Distribute the toner powder.
Holding the cartridge horizontally, slowly rock it back and forth to a 45-degree angle four or
five times to distribute the toner powder.
3. Insert the cartridge.
The cartridge fits into the slot on the underside of the raised upper section of the LaserWriter
II. Slide it in as far as it will go. Insert it narrow end first, using the directional arrows on the
cartridge as a guide. Be sure that it is seated firmly.
4. Loosen the tape tab.
Holding the cartridge in place, flex the black tab gently but firmly until it loosens. Don’t tear it
completely away; you’ll need it to pull out the sealing tape.
5. Remove the tape.
Pull the tab outward until the tape is completely removed. If the tab does come off, grasp the
tape itself and pull out.
___________________________________________________________
Warning-Be sure to remove the sealing tape with the cartridge in the printer. If you insert the
cartridge with the tape removed, toner may spill into the printer. For the same reason, avoid
transporting the printer with a cartridge installed, and always remove cartridges carefully.
___________________________________________________________
Installing the cleaning pad
The cleaning pad that comes with the toner cartridge continuously cleans the fixing rollers
while you print.
1. Remove the felt tip from the end of the cleaning pad.
When you change the cartridge and cleaning pad, you’ll use the felt tip to clean the fixing
rollers. Because the printer is new and doesn’t need cleaning, just remove the tip and discard it.
2. Lift the green felt cover that protects the fixing rollers.
3. Fit the pad into the groove on the underside of the green cover.
4. Close the green felt cover.
5. Check the print density dial.
This is a convenient time to check the print density setting. The print density dial is inside the
printer on the left.