User`s manual

change your mind.
___________________________________________________________
5. Close the Font/DA Mover by clicking Quit.
Unless you are using more than one type of printer, the LaserWriter printer resource is the
only one you need.
___________________________________________________________
Important-The LaserWriter printer resource will also work with earlier LaserWriter and
LaserWriter Plus printers. You do not need the old LaserWriter resource if you have the new
LaserWriter resource (its icon depicts the LaserWriter II) installed.
___________________________________________________________
1. Start the Macintosh with the startup disk you’re going to use.
2. Make a backup copy of the disk for safekeeping.
3. Open the System Folder icon.
4. Drag the unneeded printer resources to the Trash.
Once you have finished installing fonts, you can free up space on the startup disk by removing
the Font/DA Mover. If you want to change your font selection, however, you may have to install
it again.
___________________________________________________________
Creating application disks
If you don’t have a hard disk, you’ll probably find it convenient to keep your applications on
nonstartup disks.
1. Start your Macintosh with the application’s master disk.
2. Insert a blank disk and initialize it.
3. Give the disk a name that identifies it as an application disk.
4. Open the application disk’s icon.
5. Find the icon that represents the application itself.
In most cases, the application icon will be labeled with the application name.
6. Drag the icon to the new disk.
7. Find icons representing any other files you may need, such as help files, and drag them to the
new disk.
__________________________________________________________________
Chapter 3: Using the LaserWriter II
__________________________________________________________________
Using the LaserWriter II
Before printing with the LaserWriter II for the first time, check to make sure that the printer
is properly connected and that the switches are properly set.
___________________________________________________________
Using the Chooser
When you want to print with the LaserWriter II for the first time or after using another