Specifications

Troubleshooting Capacitor Discharge - 3
Switch off and unplug the printer, and remove the bottom panel
and lower cover. Locate capacitor C211 on the DC controller
board. Carefully jumper the two wires at the base of the capacitor
using some kind of conductive tool, as shown on the next page.
Caution: Take care not to damage the board tracings or the
components neighboring the capacitor.
Note: There are many different tools that can be used to discharge
the capacitor: a flat blade screwdriver, paper clip, or aluminum
foil doubled over. The tool illustrated is a length of lead solder. It
has the advantage of being ductile and is less apt to damage the
controller board.