Specifications

Additional Procedures I/O Board Installation - 7
Installation Verification (SC I/O Board)
Note: The following materials are required to verify
installation:
• Macintosh Plus or later
• SCSI system cable
• SCSI terminator
• “SC Printer Installation” diskette
1 Set the SCSI address to 7.
2 Turn on the printer and wait about 3 minutes.
Note: If the printer prints a startup test page, proceed
to the next page. If not, refer to “Print Engine Check” in
Flowcharts.
Note: Because the Macintosh is always assigned SCSI
number 7, you should always reset the LaserWriter IISC
address before resuming printing.