Specifications

iPhone 4 (GSM model) Take Apart — Main Camera 105
2012-02-21
6 Install (5) new cross-
head screws using
iPhone Torque Driver
and JCIS #00 Bit.
Each screw bag in the
kit is marked with the
number of the
location where it
should be installed.
• Screw #1, 452-1846
(larger head)
• Screw #2, 452-1831
• Screw #3, 452-1850
(longest thread)
• Screw #4, 452-1851
(smallest)
• Screw #5, 452-1831
Important: Make sure
the camera cowling
is centered on the
board grounding pad
under screw #1.
7 Verify the main
camera is sitting ush
with the band and is
evenly aligned.
8 Reinstall back cover
following reassembly
instructions in that
chapter.
9 Important: Check
main camera
operation and LED
ash alignment with
the Main Camera
Test procedure. If test
fails, replace camera.