Repair Guide

iPhone 13 mini
073-00322-A | 50© 2022 Apple Inc. All rights reserved.
Display I Reassembly
30. Use the gray torque driver
and Torx security bit to
install two new security
screws, one on each side of
the Lightning connector. As
you install the screws, press
lightly on the display near
the Lightning connector.
If the screws aren’t flush,
remove and discard the
screws. Repeat step 30
to install another new
set of screws. If the new
set of screws still aren’t
flush, repeat all removal
and reassembly steps.
Caution
• System Configuration is required if you’ve installed a replacement display, battery, or camera.
Disregard notifications about iPhone features on the Lock Screen until you complete System
Configuration.
• After you’ve completed all removal and reassembly steps, learn how to initiate the System
Configuration process at support.apple.com/self-service-repair.
Important