Owner`s manual
3.
Remove the cut-sheet feeder connector (Figure 50,
#1) and bracket (Figure 50, #2).
Stepper
Motor
Right Side
Left Side
1
2
FIGURE 50
4.
Using a small flat-blade screwdriver, pry back the
black plastic tab inside the hole on the right-rear side
of the frame (Figure 50, #3), and gently pull back on
the tractor assembly about 1/4 of an inch.
5. Repeat step 4 to release the left side of the assembly.
6.
When both sides have been released from the indents
on the metal frame, pull the tractor assembly straight
out the rear of the mechanical assembly (Figure 51).
2.62 / Take-Apart rev. Aug 91 ImageWriter II